Window Roll Shutters
Mounted outside the glass, where the protection actually needs to be. A physical barrier against weather, wind and unwanted access, and a noticeable difference to heat, cold and street noise, which interior blinds cannot do.
Roll Pro builds aluminum roll shutters and roll-up doors in Ontario: for windows, garages, patios and cabanas, storefront grilles, and the awkward one-offs like boathouses, service counters and bar fronts. Thirty years of building them, with warranties running up to seven years.
It is the most flexible of the three lines we carry, which makes it the one we reach for when an opening does not match anything in a catalogue. Rivett measures it, fits it with our own crew and services it afterwards.
Built in Ontario
Warranties up to seven years
We measure the opening ourselves, fit the shutter with our own crew and handle the service calls afterwards. One company for the whole opening, and one number to call when something needs adjusting.
If the opening is an ordinary window or garage, this is straightforward. If it is a boathouse, a laneway, a shed, a bar front or a service counter, it is still straightforward. That is the part of the range Roll Pro is unusually good at.
Get a QuoteThe four we fit most often. The range goes well beyond these. Ask us about anything that does not look like a standard opening.
Mounted outside the glass, where the protection actually needs to be. A physical barrier against weather, wind and unwanted access, and a noticeable difference to heat, cold and street noise, which interior blinds cannot do.
An aluminum door that coils into a compact roll above the opening instead of running back along the ceiling, so the ceiling stays free for storage, a lift, or just headroom. A modern alternative to a sectional or tilt-up door.
Enclose a porch, veranda, cabana or patio against wind, rain, snow and debris, then roll it right up when the weather turns. It extends the season on an outdoor room without building walls.
A clear rolling curtain: weather protection and an enclosed space without losing the view or the daylight. The usual answer for patios, verandas and cabanas where an aluminum shutter would close the space in too much.
Built down the road, measured on your opening,
and fitted by the crew that comes back if it needs adjusting.
Manufactured in Concord rather than imported, which shows up in lead times and in how quickly a replacement part turns up.
Roll Pro backs the range with warranties running as long as seven years depending on the product. We will tell you which term applies to your configuration at quoting stage.
Boathouses, laneways, sheds, bar fronts, service counters, shelving units and cabinets. If it is not a standard window or garage, this is usually the line that has an answer.
Motors and controls from Alpha, LiftMaster, Somfy and Nice, so the shutter can match whatever else is already running on the property.
We measure the opening, the mounting and the clearances before anything is ordered, because a shutter built to a phone measurement is one that binds.
No subcontractors. The people who fit it work for Rivett, and handle the repairs, parts and adjustments afterwards.
From the site measure to the service call two years later, our own technicians cover the whole life of the shutter.
Free on-site measure, including the awkward openings a catalogue does not cover.
Fitted, wired and commissioned by Rivett technicians.
Slats, guide rails, bottom bars, motors, remotes and controls replaced.
Scheduled servicing: rails cleaned, curtain checked, motor limits reset.
49 years of local knowledge across Ontario. Each location is staffed with
product
specialists who know the lines.
All services: doors, hardware, garage doors, fabrication
111 Industrial Drive, Unit 1
Whitby,
ON L1N 5Z9
Mon – Thu
8:00 AM – 5:00 PM
Friday
8:00 AM – 1:00 PM
Residential & commercial overhead doors, service dispatch
105 Industrial Drive, Unit 6
Whitby,
ON L1N 5Z9
Mon – Thu
8:00 AM – 5:00 PM
Friday
8:00 AM – 4:00 PM
Doors & architectural hardware
620 Cataraqui Woods Drive
Kingston,
ON K7P 1T8
Mon – Thu
8:00 AM – 5:00 PM
Friday
8:00 AM – 1:00 PM
Email all locations: sales@rivett.com
Do not see your area listed? Call 1 (905) 668-4455 (Whitby) or 1 (613) 389-5218 (Kingston). We regularly serve projects beyond these boundaries.
Free on-site estimates for residential and commercial projects. Same-day emergency dispatch for overhead door failures. One call, one company, one standard of quality since 1977.
1 (905) 668-4455 1 (613) 389-5218 1 (905) 424-2512© 2026 Rivett Architectural Hardware Ltd. All rights reserved.
